TANDBERG MCU 4500, MSE 8510 manual Syslog settings Using syslog

You can send the Event log to one or more syslog servers on the network for storage or analysis.

To configure the syslog facility, go to

In this section:

Syslog settings

Using syslog

Refer to this table for assistance when configuring Syslog settings:

	Enter the IP addresses of up to four Syslog				The number of packets sent to each configured
	receiver hosts.				host will be displayed next to its IP address.
	A configurable value for the purposes of				Choose a value that you will remember as being
	identifying events from the MCU on the Syslog				the MCU.
	host. Choose from the following options:
0		- kernel messages			: Various operating system daemons and
1		- user-level messages			processes have been found to utilize Facilities 4,
2		- mail system			10, 13 and 14 for security/authorization, audit,
3		- system daemons			and alert messages which seem to be similar.
4		- security/authorization messages (see			: Various operating systems have been found
	Note 1)
5		- messages generated internally by			to utilize both Facilities 9 and 15 for clock
					(cron/at) messages.
	syslogd
6		- line printer subsystem			Processes and daemons that have not been
7		- network news subsystem
					explicitly assigned a Facility value may use any of
8		- UUCP subsystem
					the "local use" facilities (16 to 21) or they may
9		- clock daemon (see Note 2)
					use the "user-level" facility (1) - and these are the
10			- security/authorization messages
					values that we recommend you select.
	(see Note 1)
11			- FTP daemon
12			- NTP subsystem
13			- log audit (see Note 1)
14			- log alert (see Note 1)
15			- clock daemon (see Note 2)
16			- local use 0 (local0)
17			- local use 1 (local1)
18			- local use 2 (local2)
19			- local use 3 (local3)
20			- local use 4 (local4)
21			- local use 5 (local5)
22			- local use 6 (local6)
23			- local use 7 (local7)
				163