TANDBERG MCU 4500, MSE 8510 manual Endpoint. In this case, to use call-in match

		endpoint. In this case, to use call-in match
		parameters, leave the IP address field blank and
		enter the correct username. The call will be
		matched by username.
		When using LCS, the username that will be
		matched is the user's display name (e.g. Peter
		Rabbit) rather than the sign-in name
		(bluecoat@codian.com).
The name that will be displayed in a conference		The name you enter here will override any
as a label for this endpoint.		default name configured on the endpoint. It will
		also override any other default name that might
		appear for an endpoint. For example, an
		endpoint's default name can be the name of the
		gateway through which the call was placed, or if
		the endpoint is called-in via a gatekeeper, its
		E.164 number.
		Note that once an endpoint has connected, you
		cannot change the display name.
Choose whether to use the box-wide setting for		The settings for motion (frames per second) and
motion/sharpness trade off, or configure an		sharpness (frame size or resolution) are
individual setting for this endpoint. Choose from:		negotiated between the endpoint and the MCU.
Use box-wide setting: this is the default		This setting controls how the MCU will negotiate
value. In this case, the endpoint will use		the settings to be used with this endpoint.
the motion/sharpness tradeoff setting
from the	page
Favor motion: the MCU will try and use a
high frame rate. That is, the MCU will
strongly favor a resolution of at least 25
frames per second
Favor sharpness: the MCU will use the
highest resolution that is appropriate for
what is being viewed
Balanced: the MCU will select settings
that balance resolution and frame rate
(where the frame rate will not be less
than 12 frames per second)
Choose the setting for transmitted video		Retain the default setting (use box-wide setting)
resolutions from the MCU to this endpoint. This		unless you are experiencing problems with the
setting overrides the unit-wide setting on the		display of certain resolutions by this endpoint.
page.		Endpoints advertise the resolutions that they are

able to display. The MCU then chooses from those advertised resolutions, the resolution that it will use to transmit video. However, some endpoints do not display widescreen resolutions optimally. Therefore, you might want to use this setting to restrict the resolutions available to the MCU for transmissions to this endpoint.

91