The Health Status displays information about the hardware components of the MCU. To access this information, go to 
Note that the Worst status seen conditions are those since the last time the unit was restarted.
To reset these values, click | . Refer to the table below for assistance in interpreting the information displayed. | ||||
|
|
|
|
| |
|
|
|
|
| |
| Displays two possible states: |
|
| – component is functioning properly | |
|
|
|
|
| – Check with your support |
| OK |
| provider; component might require | ||
| Out of spec |
| service | ||
| States indicate both | and | If the | column displays "Out of | |
|
| conditions. |
| spec", but | is "OK", monitor the |
|
|
|
| status regularly to verify that it was only a | |
|
|
|
| temporary condition. | |
|
|
|
|
| |
| Displays three possible states: |
|
| – temperature of the MCU is within | |
|
|
|
| the appropriate range | |
| OK |
|
| – Check the ambient | |
| Out of spec |
| temperature (should be less than 34 | ||
| Critical |
| degrees Celsius) and verify that the air | ||
|
|
|
| vents are not blocked | |
| States indicate both | and |
| – temperature of MCU is too | |
|
| conditions. |
| high. An error also appears in the event | |
|
|
|
| log indicating that the system will | |
|
|
|
| shutdown in 60 seconds if the condition | |
|
|
|
| persists | |
|
|
|
| If the | column displays "Out of |
|
|
|
| spec", but | is "OK", monitor the |
|
|
|
| status regularly to verify that it was only a | |
|
|
|
| temporary condition. | |
|
|
|
|
|
|
159
