TANDBERG MSE 8510, MCU 4500 manual Address!E.164, Adding and updating gateways

You can configure H.323 endpoints to work with the MCU by choosing . This makes it easier to add endpoints to conferences because you can choose names from a list rather than adding network addresses.

A Codian IP VCR can be configured as an H.323 endpoint and added as a participant in a conference. If the IP VCR is configured to do so, it will start recording as soon as the conference starts. You can also configure a folder's Recording ID as an endpoint and in this way, when a conference starts, the IP VCR can start recording directly into a specific folder. For more information about using the IP VCR in this way, refer to the IP VCR's online help.

Recordings on a Codian IP VCR can be configured as H.323 endpoints. In this way, an audio-only participant can contribute an IP VCR recording as his video stream (using the associated endpoint function, see Adding and updating users). This function is also useful where you have a recording that you might like to view within a conference.

Refer to the table below for tips on adding an H.323 endpoint to the MCU. After entering the settings, click

.

The name of the endpoint.

The IP address, host name, or an E.164 address	You can configure this endpoint as needing to be
(phone number).	reached via an H.323 gateway without that
	gateway being already configured on the MCU.
	To do this, set this field to be <gateway
	address>!<E.164>.
The gateway through which the endpoint	To configure a gateway on the MCU, go to
connects.	. For more information, refer to
	Adding and updating gateways.
These fields are used to identify incoming calls as	The endpoint is recognized if all filled-in fields in
being from the endpoint:	this section are matched. Fields left blank are not
	considered in the match.
Name: This must be the name that the	When you configure Call-in match parameters, an
endpoint sends to the MCU
IP address: The IP address of the endpoint	endpoint will be recognized as this pre-configured
E.164: The E.164 number with which	endpoint and the Conferencing parameters will be
the endpoint is registered with the	applied to a call from this endpoint.
gatekeeper
The name that will be displayed in a conference	The name you enter here will override any
as a label for this endpoint.	default name configured on the endpoint. It will
	also override any other default name that might
	appear for an endpoint. For example, an
	endpoint's default name can be the name of the
	gateway through which the call was placed, or if
	the endpoint is called-in via a gatekeeper, its
	E.164 number.
	Note that once an endpoint has connected, you
	cannot change the display name.
	86