stopped sending video keyframes in response to Fast Update Requests (FURs) to avoid degrading the content video sent to other conference participants. The MCU will only enter this state if the Video fast update request filtering setting is Enabled (see Configuring content settings).

The associated participant is currently supplying the conference's content channel video.

Use of this participant's main video source as the content (content channel) source has failed. This is normally because there is already a source for the content channel; either another participant's main video channel which has been configured in the same way (VNC participants are set up this way by default) or a content video channel contributed by a connected endpoint.

This message appears if packet loss is detected

Click

to open the Participant statistics page

and display details about the connection, for

between the MCU and the endpoint.

example the packet errors. See Displaying

 

statistics for a participant.

 

 

This endpoint has requested and been granted the

For more information, refer to H.243 floor and

chair control.

chair.

 

 

 

 

 

For more information, refer to H.243 floor and

 

chair control.

The endpoint has requested and been granted the

 

 

floor and its media is being broadcast to all

 

 

endpoints in the conference.

 

 

 

 

 

This situation can occur when an endpoint

 

requested the floor, was granted the floor, and

This endpoint believes it has been granted the

was then moved to another conference where

floor, but its media is not being shown to all

there was already an active floor participant.

endpoints in the conference.

 

 

 

For more information, refer to H.243 floor and

 

chair control.

 

 

 

This situation can occur if another endpoint,

 

while chair, has issued H.243 commands to make

This endpoint's media is being broadcast to all

that endpoint the floor.

endpoints in the conference, although it did not

 

 

request the floor itself.

For more information, refer to H.243 floor and

 

chair control.

Indicates that this connection is a cascade link to or from another conference.

63

Page 65
Image 65
TANDBERG MCU 4500, MSE 8510 manual Statistics for a participant, Chair control