TANDBERG MCU 4500, MSE 8510 manual Default bandwidth from MCU that is configured on, Configuring

	If you are using Microsoft OCS or LCS, you need
	to enter the full URI (for example,
	MCU@mylcs.com).
	Note that this username will be used anywhere
	where one is required in a SIP call; for example,
	it will be used where authentication is required
	with a SIP server where no registrar is used.
The password for the MCU on the SIP registrar.	You need to configure the SIP registrar with
	details of the devices that will register with it and
	create a login for each device. The password
	configured on this page needs to match the
	password in the SIP registrar. For Microsoft OCS
	or LCS, do not enter a password.
	Note that this username will be used anywhere
	where one is required in a SIP call; for example,
	it will be used where authentication is required
	with a SIP server where no registrar is used.
Identifies the network address of the SIP proxy.	If set, the proxy is used for all SIP calls, whether
	through a registrar or not.
Select a maximum bit rate to use from Microsoft	Microsoft OCS/LCS clients will try to use the
OCS/LCS clients.	maximum bit rate that the MCU advertises
	during the initial call setup. In most scenarios,
	you will not want OCS/LCS clients to use the
	Default bandwidth from MCU that is configured on
	the	page (Configuring
	global conference settings). Use this setting to
	select an appropriate bit rate for Microsoft
	OCS/LCS clients.
	<limit disabled> will cause the MCU to advertise
	the Default bandwidth from MCU.
Identifies the protocol to be used for call control	If your SIP devices use TCP, select TCP as the
messages for outgoing call connections.	outgoing transport. If your SIP devices use UDP,
	select UDP as the outgoing transport. If you want
	to use encrypted SIP, select TLS. Note that if you
	want to use TLS, you must have the encryption
	feature key (or the Secure management feature

key) and the TLS service must be enabled on the page.

Note that this unit-wide setting can be overriden on a per-configured endpoint basis if you require different settings for individual endpoints. For more information about configuring SIP endpoints, refer to Configuring SIP endpoints

Using TLS for call setup is not sufficient for the call to be considered encrypted such that it can participate in a conference which requires

127