
Whether this endpoint is allowed to receive a separate content stream when in a conference.
This setting is provided to allow you to individually configure whether or not an endpoint is allowed to receive content from a conference.
To use the content channel, the Content status must be enabled at the
page) and for any given
conference Content channel video must also be enabled in the
Choose a border size for video transmitted to this | This sets a border thickness to display around the |
endpoint. | video image. This is useful where the image is |
| displaying off the edges of the participant's |
| screen; use a border to force the image to display |
| properly. |
| Applying a border size here means that this |
| border size will always be used for this endpoint's |
| transmitted video. Note that you can also apply a |
| border to a participant in a conference from the |
| page. |
|
|
Sets the layout family to be used when calling out | If this is set to Use |
to this endpoint. | view family that has been configured via the |
| Conference settings page will be used. |
|
|
The network capacity (measured in bits per | These settings take priority over the Default |
second) used by the media channels established by | bandwidth from MCU setting configured in the |
the MCU to a single participant. | global Conference settings (see Conference |
| settings). |
|
|
The maximum combined media bandwidth | These settings take priority over the Default |
advertised by the MCU to endpoints. | bandwidth to MCU setting configured in the global |
| Conference settings (see Conference settings). |
|
|
Whether this endpoint is able to change their | This setting takes precedence over the per- |
view layout via | conference layout control setting for conferences |
DTMF tones. | that the endpoint is invited into. |
|
|
Set the initial audio status of an endpoint to be | If set to muted, when the endpoint joins a |
either active or muted. | conference, it will not be able to contribute audio |
| to the conference. For example, you can mute |
| audio from an endpoint if somebody wants to be |
| seen in the conference, but does not want to |
| contribute verbally. You can mute both audio and |
| video if required. This can be altered during the |
| course of the conference by going to |
| and clicking on the name of a conference and |
| altering this participant's settings. |
|
|
Set the initial video status of an endpoint to be | If set to muted, when the endpoint joins a |
either active or muted. | conference, it will not be able to contribute video |
|
|
| 88 |