Texas Instruments TMS320TCI6486 manual Mdio User Access Register 1 USERACCESS1

www.ti.com MDIO Registers

4.14 MDIO User Access Register 1 (USERACCESS1)

The MDIO user access register 1 (USERACCESS1) is shown in Figure 41 and described in Table 34.

Figure 41. MDIO User Access Register 1 (USERACCESS1)

31	30	29	28	26	25	21	20	16
GO	WRITE	ACK		Reserved		REGADR		PHYADR
R/WS-0	R/W-0	R/W-0		R-0		R/W-0		R/W-0
15								0
						DATA
						R/W-0
LEGEND: R = Read only; R/W = Read/Write; R/WS = Read/Write 1 to set; -n= value after reset

Table 34. MDIO User Access Register 1 (USERACCESS1) Field Descriptions

Bit	Field	Value	Description
31	GO		Go bit. Writing a 1 to this bit causes the MDIO state machine to perform an MDIO access when it is
			convenient for it to do so, this is not an instantaneous process. Writing a 0 to this bit has no effect.
			This bit is write-able only if the MDIO state machine is enabled. This bit will self clear when the
			requested access has been completed. Any writes to the USERACCESS0 register are blocked
			when the go bit is 1.
30	WRITE		Write enable bit. Setting this bit to a 1 causes the MDIO transaction to be a register write, otherwise
			it is a register read.
		0	The user command is a read operation
		1	The user command is a write operation
29	ACK		Acknowledge bit. This bit is set if the PHY acknowledged the read transaction.
28-26	Reserved	0	Reserved
25-21	REGADR		Register address bits. This field specifies the PHY register to be accessed for this transaction.
20-16	PHYADR		PHY address bits. This field specifies the PHY to be accessed for this transaction.
15-0	DATA		User data bits. These bits specify the data value read from or to be written to the specified PHY
			register.

SPRUEF8F –March 2006 –Revised November 2010	C6472/TCI6486 EMAC/MDIO	89
Submit Documentation Feedback

Copyright © 2006–2010, Texas Instruments Incorporated