Installing the System Board/DC-IN Jack/RTC Battery

4 Replacement Procedures

The following describes the procedure for installing the system board/DC-IN Jack/RTC Battery (See Figure 4-29, 4-30).

1.Attach the FIR dummy cover on the base assembly. Make sure the latches are setured.

2.Install the modem jack on the base assembly.

3.Connect the DC-IN jack cable to PJ8800 on the system board.

4.Connect the RTC battery cable to PJ8790 on the system board.

5.Insert the system board into the base assembly from the microphone and headphone jack side first.

6.Install the DC-IN jack to the base assembly.

7.Insert the RTC battery into the slot on the base assembly.

8.Secure the system board with the following screws.

• M2.5x5

THIN BIND screw x2

4-45

Toshiba A10 manual Installing the System Board/DC-IN Jack/RTC Battery