Toshiba A10 manual Procedure 3 Connector Check and Replacement Check, PJ4600

2.5 3.5” FDD Troubleshooting 2 Troubleshooting Procedures

Procedure 3 Connector Check and Replacement Check

The USB connector may be disconnected from the system board. Check visually that the connector is connected firmly.

Check 1 Make sure the following cable and connector are firmly connected to the system board.

USB FDD

SystemシステムBoard基板

PJ4600

If any of the connections are loose, reconnect firmly and repeat Procedure 2. If there is still an error, go to Check 2.

Check 2 The USB FDD may be defective or damaged. Replace it with a new one. If the FDD is still not functioning properly, perform Check 3.

Check 3 Replace the system board with a new one following the steps in Chapter 4, Replacement Procedures.

Satellite A10/TECRA A1/Satellite Pro A10 Maintenance Manual (960-445) 2-41