Toshiba A10 manual Replacing 14 Inch TMD fluorescent lamp

4 Replacement Procedures 4.18 Fluorescent Lamp

Attaching the tapes and insulation sheet

1.Attach the PCB insulation sheet (one point).

2.Attach the tape for the bezel to the bottom area close to the lamp (two points).

3.Attach the tape for fixing the FL tube cable (one point).

CAUTION: When attaching tape and insulation sheet, be careful not to damage the TAB and lamp cable connections.

絶Att縁acシーhiトng貼りth付eけinsulation sheet

1 1

Attach the sheet after removing slack.

ＰThＣＢeがframeフレームmusに t not be 乗overlaidり上げて無withいこtheと PCB.

Align the sheet with the reflector's edge.

Align the sheet with the module's edge.

Attach the sheet by pressing it so that the bezel may not "fly".

Align the sheet with the reflector's edge.

2

2

The tape edge must not モprotrudeジュール表from面に出theないsurfaceこと of the module.

Align the sheet with the module's edge.

モThジeューtapeル表e面dにge出なmusいこtとnot protrude from the surface of the module.

Attaching the tape for the bezel ベゼルテープ貼り付け

Requirements for attachment:

The tape edge must not go

beyond the bezel's貼り基準edge： .

ベゼル端から出ないこと

5

Requirements for attachment: The tape edge must not go 貼beyondり基準： the module's edge.

モジュール端を目安に貼る

Rubber cap: Must cover the opening for the cable.

Figure 4-56 Replacing 14 Inch TMD fluorescent lamp (12)

4-76 Satellite A10/TECRA A1/Satellite Pro A10 Maintenance Manual (960-445)