Toshiba A10 manual Replacing 14 Inch TMD fluorescent lamp

4 Replacement Procedures 4.18 Fluorescent Lamp

Setting the bezel

1. Start installing the bezel in the upward direction until it stops at the top left corner.

NOTE: The GND-CU and lamp reflector on the left-hand side must not go beyond the edges of the bezel.

Be careful not to damage the cables and TAB.

The bezel latches must be engaged (there are five latches on the top edge, and two latches on the bottom edge).

Next, fit thebezel’sedgeclosetotheTAB. Close thefivelatches.

2

2

2

2

2

1

Thefoldof GND-CUmust not
ＧＮＤ－ＣＵ折り曲げ有り．
gobeyondthebezel’sedge.	First, fit thebezel’sedgeclosetothelamp.
ベゼルの外に出ないこと．
Thefoldof reflector must not go	Usecarenot todamagethecable.
リフレクタ折り曲げ有り．
beyondthe bezel’sedge.	ラTwoッチ２latches箇所有り．
ベゼルの外に出ないこと

Figure 4-54 Replacing 14 Inch TMD fluorescent lamp (10)

4-74 Satellite A10/TECRA A1/Satellite Pro A10 Maintenance Manual (960-445)