Toshiba M10, TECRA manual Installing the Cover assembly and Base assembly

4.16 Cover assembly and Base assembly 4 Replacement Procedures

Installing the Cover assembly and Base assembly

To install the cover assembly and base assembly, follow the steps below and refer to Figure 4-28 to 4-30.

1.Place the cover assembly on the base assembly and secure them with the following screws.

• M2.5⋅10B FLAT HEAD screw ⋅4

2.Insert the core to the Smart card FFC and connect the Smart card FFC to the connector CN2170 on the system board. Stick the acetate tape in place.

NOTE: Set the core next to the connector portion of the Smart card FFC and stick the acetate tape on them.

Acetate tape

Core

Connector

3.Connect the touch pad FFC, Bluetooth harness, camera harness and LCD harness to the connector CN9550, CN4440, CN9540 and CN5000 on the system board.

4.Turn over the computer and secure the cover assembly and base assembly with the following screws.

•	M2.5⋅16B	FLAT HEAD screw	⋅3	(“16” in the figure 4-28)
•	M2.5⋅10B	FLAT HEAD screw	⋅8	(“10” in the figure 4-28)
•	M2.5⋅5B	FLAT HEAD screw	⋅2	(“5” in the figure 4-28)

TECRA M10 Maintenance Manual (960-685) [CONFIDENTIAL] 4-49