Toshiba M10, TECRA manual Installing the RGB harness/RJ45 harness

4.18 RGB harness/RJ45 harness 4 Replacement Procedures

Installing the RGB harness/RJ45 harness

To install the RGB harness/RJ45 harness, follow the steps below and refer to Figure 4-33 and 4-34.

1.Turn up the insulator and connect the RJ45 harness to the connector CN4100 on the system board.

2.Set the RJ45 harness into the slot of the base assembly and arrange it to the guides.

3.Connect the RGB harness to the connector CN9510 on the system board.

4.Set the RGB harness into the slot of the base assembly and arrange it to the guides.

5.Secure the RGB harness with the following screw.

• M2.5⋅6C Tapping screw ⋅1

TECRA M10 Maintenance Manual (960-685) [CONFIDENTIAL] 4-55