4.22 CPU/CPU fin/DC fan | 4 Replacement Procedures |
4.22 CPU/CPU fin/DC fan
Removing the CPU/CPU fin/DC fan
To remove the CPU/CPU fin/DC fan, follow the steps below and refer to Figure
1.Disconnect the fan harness from the connector CN8771 on the system board.
2.Remove the following screws and heat sink plate.
• M2.0⋅4B | BIND screw | ⋅4 |
3. Remove the following screws and CPU fin (with the DC fan).
• M2.0⋅4B | BIND screw | ⋅2 |
NOTE: When removing the heat sink plate and CPU fin, be sure to remove the screws in the reverse order of the number marked (4 to 1 and 2 to 1) on the heat sink plate and board spring of the CPU fin.
| M2.0x4B BIND | ||
| Board spring | ||
Heat sink plate |
| Fan harness | |
M2.0x4B BIND | |||
| |||
M2.0x4B BIND
CPU fin CN8771
Figure 4-40 Removing the CPU fin/DC fan (1)
TECRA M10 Maintenance Manual | [CONFIDENTIAL] |
