Toshiba M10, TECRA 4.25 Sound board/Microphone harness

4 Replacement Procedures 4.25 Sound board/Microphone harness
4.25 Sound board/Microphone harness
Removing the Sound board/Microphone harness
To remove the sound board/microphone harness, follow the steps below and refer to Figure
4-47.
1. Peel off the glass tape.
2. Remove the following screws and sound board/microphone harness from the slot.
• M2.5×4B FLAT HEAD screw ×2
3. Disconnect the microphone harness from the connector CN6050 on the sound board.
4. Disconnect the sound board FFC from the connector CN9630 on the sound board.
M2.5x4B FLAT HEAD
4-74 [CONFIDENTIAL] TECRA M10 Maintenance Manual (960-685)
Figure 4-47 Removing the sound board/microphone harness
Sound board
CN9630
Glass tape
Microphone
harness
Sound board FFC
M2.5x4B FLAT HEAD
CN6050