Toshiba M10, TECRA manual RGB harness/RJ45 harness Replacement Procedures

4.18 RGB harness/RJ45 harness 4 Replacement Procedures

4.18 RGB harness/RJ45 harness

Removing the RGB harness/RJ45 harness

To remove the RGB harness/RJ45 harness, follow the steps below and refer to Figure 4-33 and 4-34.

1.Turn up the insulator and disconnect the RGB harness from the connector CN9510 on the system board.

2.Remove the following screw and take out the RGB harness from the slot of the base assembly.

• M2.5⋅6C Tapping screw ⋅1

M2.5x6C Tapping

RGB harness

Insulator

CN9510

Figure 4-33 Removing the RGB harness

TECRA M10 Maintenance Manual (960-685) [CONFIDENTIAL] 4-53