
4 Replacement Procedures | 4.31 Camera module/Wireless LAN antenna/3G antenna |
4.31 Camera module/Wireless LAN antenna/3G antenna
Removing the Camera module/Wireless LAN antenna/3G antenna
To remove the camera module/wireless LAN antenna/3G antenna, follow the steps below and refer to Figure
1.Turn up the insulators (ANTENA HLD INSULATOR) and peel off the acetate tapes securing the wireless LAN antenna cables, 3G antenna cables and camera harness.
2.Take out the camera module from the slot and disconnect the camera harness from the connector on the camera module.
3.Peel off the wireless LAN antennas and 3G antennas from the LCD cover.
NOTE: Do not reuse the removed camera module, wireless LAN antennas and 3G antennas. Be sure to use new camera module, wireless LAN antenna or 3G antenna.
| Camera harness | Wireless LAN antenna (black) | |
|
| ||
Camera module |
|
|
|
Wireless LAN |
|
| Insulator |
|
| ||
antenna (white) |
|
|
Acetate tape
LCD COVER ASSY | Insulator |
Figure 4-60 Removing the camera module/wireless LAN antenna/3G antenna
| TECRA M10 Maintenance Manual |