Toshiba TECRA, M10 manual Replacing the 14.1-inch WXGA+ LG Fluorescent Lamp

4 Replacement Procedures 4.35 Fluorescent Lamp

4.35.3 Replacing the 14.1-inch WXGA+ LG Fluorescent Lamp

CAUTION: When replacing the fluorescent lamp, wear finger covers or gloves to avoid contaminating or damaging the LCD panel and backlight unit.

Removing the fluorescent lamp

To remove the 14.1-inch WXGA+ LG fluorescent lamp, follow the steps below and refer to figures 4-80 to 4-83.

Disassembly of outside tape / Cover shield

1.Disassembly of Tape Adhesive1 used for B/L Wire fixing.

2.Disassembly of Tape Adhesive2 used for Top case fixing.

CAUTION: Pressure or stress should not be given on Top case during this process.

3. Disassembly of Cover shield (G)3.

CAUTION: Pressure or stress should not be given on Gate COF.

4. Disassembly of Cover shield (S)4.

CAUTION: Pressure or stress should not be given on Source PCB. Usage of gloves with anti-electric discharge coating is recommended to eliminate possible damage on circuits occurred by ESC.

Figure 4-80 Replacing 14.1-inch LG fluorescent lamp (WXGA+) (1)

4-122 [CONFIDENTIAL] TECRA M10 Maintenance Manual (960-685)