Xerox CX manual Exceptions tab in the Job Parameters window

Exceptions tab in the Job Parameters window 117

Parameter

Slip Sheets

Image Position

Option

Slip sheets between copies

Same on both sides

Rear

Lead

Center

Description

Prints slip sheets with your job. If a job is collated, the slip sheets are printed between sets. If a job is not collated, the slip sheets are printed between groups.

●Tray: The tray in which the specified media type is loaded.

●Frequency: Type the number of slip sheets you want to print. The default is set to 1; a slip sheet is printed between each set.

Shifts the image on the sheet's second side (face down image) according to the shift on the sheet's first side (face up image).

The sheet's edge near the printer rear, where printing stops.

The edge of a sheet at which printing begins.

Tip: Use this option to move duplex page data away from the spine.

Prints your job in the center of the page.

Exceptions tab in the Job Parameters window

Parameter

Type

Paper stock

Option

Description

Here you can define which type of exception to apply to your document. You can select from the following:

●Page range: Type the range of pages for the exception.

●Front cover or Back cover: Select the Duplex check box to print the first two (or last row) pages of the job as the cover page (back cover).

Note: If the imposition type is Saddle Stitch, select Cover to print both a front and back cover page on a different media type. Select Middle sheet to print the internal sheets on a different media type.

●Inserts: Select Before or After and type the page number that will precede or follow the insert. Then, in the Quantity box, type the total number of inserts you want to add.

Select the media type for the pages you want to apply the exception.