Chapter 9 DMZ Screens
Figure 121 NETWORK > DMZ
The following table describes the labels in this screen.
Table 46 NETWORK > DMZ
LABEL | DESCRIPTION |
DMZ TCP/IP |
|
|
|
IP Address | Type the IP address of your ZyWALL’s DMZ port in dotted decimal notation. |
| Note: Make sure the IP addresses of the LAN, WAN, WLAN and |
| DMZ are on separate subnets. |
|
|
IP Subnet Mask | The subnet mask specifies the network number portion of an IP address. Your |
| ZyWALL will automatically calculate the subnet mask based on the IP address |
| that you assign. Unless you are implementing subnetting, use the subnet mask |
| computed by the ZyWALL 255.255.255.0. |
|
|
RIP Direction | RIP (Routing Information Protocol, RFC1058 and RFC 1389) allows a router to |
| exchange routing information with other routers. The RIP Direction field controls |
| the sending and receiving of RIP packets. Select the RIP direction from Both/In |
| Only/Out Only/None. When set to Both or Out Only, the ZyWALL will |
| broadcast its routing table periodically. When set to Both or In Only, it will |
| incorporate the RIP information that it receives; when set to None, it will not send |
| any RIP packets and will ignore any RIP packets received. Both is the default. |
202 |
| |
ZyWALL 2WG User’s Guide |
| |
|
|
|