Chapter 2 Introducing the Web Configurator
The following table describes the labels in this screen.
Table 7 HOME > Show Statistics
LABEL | DESCRIPTION |
| Click the icon to display the chart of throughput statistics in router mode. |
|
|
Port | These are the ZyWALL’s interfaces. |
|
|
Status | For the WAN interface(s) and the Dial Backup port, this displays the port speed and |
| duplex setting if you’re using Ethernet encapsulation or the remote node name for a |
| PPP connection and Down (line is down or not connected), Idle (line (ppp) idle), |
| Dial (starting to trigger a call) or Drop (dropping a call) if you’re using PPPoE |
| encapsulation. Dial backup is not available in bridge mode. |
| For the LAN, DMZ and WLAN ports, this displays the port speed and duplex setting. |
| For the WLAN card, this displays the transmission rate when WLAN is enabled or |
| Down when WLAN is disabled. |
|
|
TxPkts | This is the number of transmitted packets on this port. |
|
|
RxPkts | This is the number of received packets on this port. |
|
|
Collisions | This displays the number of collisions on this port in bridge mode. |
|
|
Tx B/s | This displays the transmission speed in bytes per second on this port. |
|
|
Rx B/s | This displays the reception speed in bytes per second on this port. |
|
|
Up Time | This is the total amount of time the line has been up. |
|
|
System Up Time | This is the total time the ZyWALL has been on. |
|
|
Automatic | Select a number of seconds or None from the |
Refresh Interval | screen statistics automatically at the end of every time interval or to not update the |
| screen statistics. |
|
|
Refresh | Click this button to update the screen’s statistics immediately. |
|
|
Click the icon in the Show Statistics screen when the ZyWALL is set to router mode. This screen shows you a line chart of each port’s throughput statistics.
Figure 12 HOME > Show Statistics > Line Chart
| 75 |
ZyWALL 2WG User’s Guide | |
|
|