ZyXEL Communications 2WG manual 65

	Chapter 2 Introducing the Web Configurator
Table 3 Web Configurator HOME Screen in Router Mode (continued)
LABEL	DESCRIPTION
3G Card ESN	This field is available only when you insert a CDMA (Code Division Multiple
	Access) 3G card.
	This shows the ESN (Electronic Serial Number) of the inserted CDMA 3G card.
	The ESN is the serial number of a CDMA 3G card and is similar to the IMEI on a
	GSM or UMTS 3G card.
Enter PIN code	If the PIN code you specified in the WAN 2 screen is not the right one for the card
again	you inserted, this field displays allowing you to enter the correct PIN code. Enter
	the PIN code (four to eight digits) for the inserted 3G card.
Apply	Click Apply to save the correct PIN code and replace the one you specified in the
	WAN 2 screen.
PUK Code	If you enter the PIN code incorrectly three times, the SIM card will be blocked by
	your ISP and you cannot use the account to access the Internet. You should get
	the PUK (Personal Unblocking Key) code (four to eight digits) from your ISP.
	Enter the PUK code to enable the SIM card. If an incorrect PUK code is entered
	10 times, the SIM card will be disabled permanently. You then need to contact
	your ISP for a new SIM card.
New PIN Code	Configure a PIN code for the SIM card. You can specify any four to eight digits to
	have a new PIN code or enter the previous PIN code.
Confirm New PIN	Enter the PIN code again for confirmation.
Code
Apply	Click Apply to save your changes in this section.
Reset budget	This field displays if you have enabled budget control but insert a 3G card with a
counters, resume	different user account from the one for which you configured budget control.
budget control	Select this option to have the ZyWALL do budget calculation starting from 0 but
	use the previous settings.
Resume budget	This field displays if you have enabled budget control but insert a 3G card with a
control	different user account from the one for which you configured budget control.
	Select this option to have the ZyWALL keep the existing statistics and continue
	counting.
Disable budget	This field displays if you have enabled budget control but insert a 3G card with a
control	different user account from the one for which you configured budget control.
	Select this option to disable budget control.
	If you want to enable and configure new budget control settings for the new user
	account, go to the WAN 2 screen.
	The ZyWALL keeps the existing statistics if you do not change the budget control
	settings. You could reinsert the original card and enable budget control to have
	the ZyWALL continue counting the budget control statistics.
Apply	Click Apply to save your changes in this section.
Enter modem	This field only displays when you insert a 3G card and the internal modem on the
unlock code	3G card is blocked.
	Enter a key to enable the internal modem on your 3G card. By default, the key is
	the last four digits of your phone number used to dial up the 3G connection.
	Otherwise, you need to get the key from your service provider.
Apply	Click Apply to save your changes in this section.
Remaining Time	This field is available only when you enable budget control in the 3G (WAN 2)
Budget	screen.
	This shows the amount of time (in hours and minutes) the 3G connection can still
	be used before the ZyWALL takes the actions you specified in the 3G (WAN 2)
	screen.

	65
ZyWALL 2WG User’s Guide