Chapter 43 Firmware and Configuration File Maintenance

8Enter “quit” to exit the ftp prompt. The ZyWALL will automatically restart after a successful restore process.

43.4.2Restore Using FTP Session Example

Figure 436 Restore Using FTP Session Example

ftp> put config.rom rom-0 200 Port command okay

150 Opening data connection for STOR rom-0

226 File received OK

221 Goodbye for writing flash

ftp: 16384 bytes sent in 0.06Seconds 273.07Kbytes/sec. ftp>quit

Refer to Section 43.3.5 on page 650 to read about configurations that disallow TFTP and FTP over WAN.

43.4.3 Restore Via Console Port

Restore configuration via console port by following the HyperTerminal procedure shown next. Procedures using other serial communications programs should be similar.

1Display menu 24.6 and enter “y” at the following screen.

Figure 437 System Maintenance: Restore Configuration

Ready to restore Configuration via Xmodem.

Do you want to continue (y/n):

2The following screen indicates that the Xmodem download has started.

Figure 438 System Maintenance: Starting Xmodem Download Screen

Starting XMODEM download (CRC mode) ...CCCCCCCCC

3Run the HyperTerminal program by clicking Transfer, then Send File as shown in the following screen.

654

 

ZyWALL 2WG User’s Guide