Chapter 30 WAN and Dial Backup Setup
30.4.2 Remote Node Profile (3G WAN)Enter 2 in Menu 11 - Remote Node Setup to open Menu 11.2 - Remote Node Profile (3G WAN) (shown below) and configure the setup for your 3G connection.
Figure 346 Menu 11.2: Remote Node Profile (3G WAN)
| Menu 11.2 - Remote Node Profile (3G WAN) | |
Rem Node Name= WAN 2 | ||
Active= Yes | Edit IP= No | |
Outgoing: | ||
Edit Script Options= No | ||
My Login= test
My Password= ********
Retype to Confirm= ********
Authen= CHAP/PAP
Pri Phone #= *99#
Always On= No
Session Options:
Edit Filter Sets= No
Idle Timeout(sec)= 100
Press ENTER to Confirm or ESC to Cancel:
The following table describes the fields in this menu.
Table 209 Menu 11.2: Remote Node Profile (3G WAN)
FIELD | DESCRIPTION |
Rem Node | Enter a descriptive name for the remote node. This field can be up to eight |
Name | characters. WAN 2 denotes a 3G WAN connection but you can change that. |
|
|
Active | Press [SPACE BAR] and then [ENTER] to select Yes to enable the remote node or |
| No to disable the remote node. |
|
|
Outgoing |
|
|
|
My Login | Enter the login name assigned by your ISP for this remote node. |
|
|
My Password | Enter the password assigned by your ISP for this remote node. |
|
|
Retype to | Enter your password again to make sure that you have entered is correctly. |
Confirm |
|
|
|
Authen | This field sets the authentication protocol used for outgoing calls. |
| Options for this field are: |
| CHAP/PAP - Your ZyWALL will accept either CHAP or PAP when requested by this |
| remote node. |
| CHAP - accept CHAP only. |
| PAP - accept PAP only. |
|
|
Pri Phone # | Enter the phone number (dial string) used to dial up a connection to your service |
| provider’s base station. Your ISP should provide the phone number. |
| For example, *99# is the dial string to establish a GPRS or 3G connection in Taiwan. |
|
|
556 |
| |
ZyWALL 2WG User’s Guide |
| |
|
|
|