Chapter 3 Wizard Setup
Figure 28 VPN Wizard: Gateway Setting
The following table describes the labels in this screen.
Table 16 VPN Wizard: Gateway Setting
LABEL | DESCRIPTION |
Gateway Policy |
|
Property |
|
|
|
Name | Type up to 32 characters to identify this VPN gateway policy. You may use any |
| character, including spaces, but the ZyWALL drops trailing spaces. |
|
|
Gateway Policy |
|
Setting |
|
|
|
My ZyWALL | When the ZyWALL is in router mode, enter the WAN IP address or the domain name |
| of your ZyWALL or leave the field set to 0.0.0.0. |
| The following applies if the My ZyWALL field is configured as 0.0.0.0: |
| • When the WAN interface operation mode is set to Active/Passive, the ZyWALL |
| uses the IP address (static or dynamic) of the WAN interface that is in use. |
| • When the WAN interface operation mode is set to Active/Active, the ZyWALL |
| uses the IP address (static or dynamic) of the primary (highest priority) WAN |
| interface to set up the VPN tunnel as long as the corresponding WAN1 or WAN2 |
| connection is up. If the corresponding WAN1 or WAN2 connection goes down, |
| the ZyWALL uses the IP address of the other WAN interface. |
| • If both WAN connections go down, the ZyWALL uses the dial backup IP address |
| for the VPN tunnel when using dial backup or the LAN IP address when using |
| traffic redirect. See the chapter on WAN for details on dial backup and traffic |
| redirect. |
| When the ZyWALL is in bridge mode, this field is |
| ZyWALL’s IP address. |
|
|
Remote | Enter the WAN IP address or domain name of the remote IPSec router (secure |
Gateway | gateway) in the field below to identify the remote IPSec router by its IP address or a |
Address | domain name. Set this field to 0.0.0.0 if the remote IPSec router has a dynamic WAN |
| IP address. |
|
|
Back | Click Back to return to the previous screen. |
|
|
Next | Click Next to continue. |
|
|
| 91 |
ZyWALL 2WG User’s Guide | |
|
|