|
| Chapter 37 IP Static Route Setup |
| Table 223 Menu 12. 1: Edit IP Static Route | |
| FIELD | DESCRIPTION |
| IP Subnet Mask | Enter the IP subnet mask for this destination. |
|
|
|
| Gateway IP | Enter the IP address of the gateway. The gateway is an immediate neighbor of your |
| Address | ZyWALL that will forward the packet to the destination. On the LAN, the gateway |
|
| must be a router on the same segment as your ZyWALL; over the WAN, the |
|
| gateway must be the IP address of one of the remote nodes. |
|
|
|
| Metric | Enter a number from 1 to 15 to set this route’s priority among the ZyWALL’s routes |
|
| (see Section 8.6 on page 170). The smaller the number, the higher priority the route |
|
| has. |
|
|
|
| Private | This parameter determines if the ZyWALL will include the route to this remote node |
|
| in its RIP broadcasts. If set to Yes, this route is kept private and not included in RIP |
|
| broadcast. If No, the route to this remote node will be propagated to other hosts |
|
| through RIP broadcasts. |
|
|
|
| Once you have completed filling in this menu, press [ENTER] at the message “Press ENTER to | |
| Confirm…” to save your configuration, or press [ESC] to cancel. | |
|
|
|
| 593 |
ZyWALL 2WG User’s Guide | |
|
|