ZyXEL Communications 2WG 22.15 DNS

Chapter 22 Remote Management

The following table describes the labels in this screen.

Table 148 ADVANCED > REMOTE MGMT > SNMP

LABEL	DESCRIPTION
SNMP
Configuration

Get Community	Enter the Get Community, which is the password for the incoming Get and
	GetNext requests from the management station. The default is public and allows all
	requests.

Set Community	Enter the Set community, which is the password for incoming Set requests from
	the management station. The default is public and allows all requests.

Trap

Community	Type the trap community, which is the password sent with each trap to the SNMP
	manager. The default is public and allows all requests.

Destination	Type the IP address of the station to send your SNMP traps to.

SNMP

Service Port	You may change the server port number for a service if needed, however you must
	use the same port number in order to use that service for remote management.

Service Access	Select the interface(s) through which a computer may access the ZyWALL using
	this service.

Secure Client IP	A secure client is a “trusted” computer that is allowed to communicate with the
Address	ZyWALL using this service.
	Select All to allow any computer to access the ZyWALL using this service.
	Choose Selected to just allow the computer with the IP address that you specify to
	access the ZyWALL using this service.

Apply	Click Apply to save your customized settings.

Reset	Click Reset to begin configuring this screen afresh.

22.15 DNS

Use DNS (Domain Name System) to map a domain name to its corresponding IP address and vice versa. Refer to Chapter 8 on page 165 for more information.

Click ADVANCED > REMOTE MGMT > DNS to change your ZyWALL’s DNS settings. Use this screen to set from which IP address the ZyWALL will accept DNS queries and on which interface it can send them your ZyWALL’s DNS settings. This feature is not available when the ZyWALL is set to bridge mode.

	457
ZyWALL 2WG User’s Guide	457