Chapter 30 WAN and Dial Backup Setup
Table 204 Advanced WAN Port Setup: Call Control Parameters
FIELD | DESCRIPTION |
Call Control |
|
|
|
Dial Timeout (sec) | Enter a number of seconds for the ZyWALL to keep trying to set up an outgoing |
| call before timing out (stopping). The ZyWALL times out and stops if it cannot set |
| up an outgoing call within the timeout value. |
|
|
Retry Count | Enter a number of times for the ZyWALL to retry a busy or |
| number before blacklisting the number. |
|
|
Retry Interval (sec) | Enter a number of seconds for the ZyWALL to wait before trying another call after |
| a call has failed. This applies before a phone number is blacklisted. |
|
|
Drop Timeout (sec) | Enter a number of seconds for the ZyWALL to wait before dropping the DTR |
| signal if it does not receive a positive disconnect confirmation. |
|
|
Call Back Delay | Enter a number of seconds for the ZyWALL to wait between dropping a callback |
(sec) | request call and dialing the |
|
|
When you have completed this menu, press [ENTER] at the prompt “Press ENTER to Confirm…” to save your configuration, or press [ESC] at any time to cancel.
30.3.3 Remote Node Profile (Backup ISP)Enter 3 in Menu 11 - Remote Node Setup to open Menu 11.3 - Remote Node Profile (Backup ISP) (shown below) and configure the setup for your Dial Backup port connection. Not all fields are available on all models.
Figure 341 Menu 11.3: Remote Node Profile (Backup ISP)
Menu 11.3 - Remote Node Profile (Backup ISP) | ||
Rem Node Name= |
| |
Active= No | Edit IP= No | |
Outgoing: | ||
Edit Script Options= No | ||
My Login= ChangeMe | Telco Option: | |
My Password= ******** | ||
Retype to Confirm= ******** | Allocated Budget(min)= 0 | |
Authen= CHAP/PAP | Period(hr)= 0 | |
Pri Phone #= 0 | Schedules= | |
Sec Phone #= | Always On= No | |
Session Options:
Edit Filter Sets= No
Idle Timeout(sec)= 100
Press ENTER to Confirm or ESC to Cancel:
| 549 |
ZyWALL 2WG User’s Guide | |
|
|