Chapter 27 Maintenance
Figure 309 MAINTENANCE > General Setup
The following table describes the labels in this screen.
Table 184 MAINTENANCE > General Setup
LABEL | DESCRIPTION |
General Setup |
|
|
|
System Name | Choose a descriptive name for identification purposes. It is recommended you enter |
| your computer’s “Computer name” in this field. This name can be up to 30 |
| alphanumeric characters long. Spaces are not allowed, but dashes |
| underscores "_" are accepted. |
|
|
Domain Name | The Domain Name entry is what is propagated to the DHCP clients on the LAN. If |
| you leave this blank, the domain name obtained by DHCP from the ISP is used. |
| While you must enter the host name (System Name), the domain name can be |
| assigned from the ZyWALL via DHCP. |
| Enter the domain name (if you know it) here. If you leave this field blank, the ISP |
| may assign a domain name via DHCP. |
| The domain name entered by you is given priority over the ISP assigned domain |
| name. |
|
|
Administrator | Type how many minutes a management session (either via the web configurator or |
Inactivity Timer | SMT) can be left idle before the session times out. The default is 5 minutes. After it |
| times out you have to log in with your password again. Very long idle timeouts may |
| have security risks. A value of "0" means a management session never times out, |
| no matter how long it has been left idle (not recommended). |
|
|
Apply | Click Apply to save your changes back to the ZyWALL. |
|
|
Reset | Click Reset to begin configuring this screen afresh. |
|
|
27.3 Configuring Password
Click MAINTENANCE > Password to open the following screen. Use this screen to change the ZyWALL’s management password.
512 |
| |
ZyWALL 2WG User’s Guide |
| |
|
|
|