Chapter 46 IP Policy Routing
2Select Edit in the Select Command field; type the index number of the rule you want to configure in the Select Rule field and press [ENTER] to open Menu 25.1 - IP Routing Policy Setup (see the next figure).
Figure 457 Menu 25.1: IP Routing Policy Setup
Menu 25.1 - IP Routing Policy Setup
Rule Index= 1 |
|
| Active= Yes |
Criteria: | = | 6 |
|
IP Protocol | Packet length= 40 | ||
Type of Service= | Normal | ||
Precedence | = | 0 | Len Comp= Equal |
Source: |
|
| end= 1.1.1.1 |
addr start= 1.1.1.1 | |||
port start= 20 |
| end= 25 | |
Destination: |
|
| end= 2.2.2.5 |
addr start= 2.2.2.2 | |||
port start= 20 |
| end= 25 | |
Action= Matched |
| |
Gateway | Type= IP Address | Redirect packet= N/A |
Gateway | addr = 192.168.1.1 | |
Type of | Service= Max Thruput | Log= No |
Precedence | = 0 | from= No |
Edit policy to packets received | ||
| Press ENTER | to Confirm or ESC to Cancel: |
The following table describes the fields in this screen.
Table 250 Menu 25.1: IP Routing Policy Setup
FIELD | DESCRIPTION |
Rule Index | This is the index number of the routing policy selected in Menu 25 - IP Routing |
| Policy Summary. |
|
|
Active | Press [SPACE BAR] and then [ENTER] to select Yes to activate the policy. |
|
|
Criteria |
|
|
|
IP Protocol | Enter a number that represents an IP layer 4 protocol, for example, UDP=17, |
| TCP=6, ICMP=1 and Don't care=0. |
|
|
Type of Service | Prioritize incoming network traffic by choosing from Don't Care, Normal, Min |
| Delay, Max Thruput or Max Reliable. |
|
|
Precedence | Precedence value of the incoming packet. Press [SPACE BAR] and then [ENTER] |
| to select a value from 0 to 7 or Don't Care. |
|
|
Packet Length | Type the length of incoming packets (in bytes). The operators in the Len Comp |
| (next field) apply to packets of this length. |
|
|
Len Comp | Press [SPACE BAR] and then [ENTER] to choose from Equal, Not Equal, Less, |
| Greater, Less or Equal or Greater or Equal. |
|
|
Source |
|
|
|
addr start / end | Source IP address range from start to end. |
|
|
port start / end | Source port number range from start to end; applicable only for TCP/UDP. |
|
|
Destination |
|
|
|
| 675 |
ZyWALL 2WG User’s Guide | |
|
|