Appendix
TROUBLESHOOTING
If you believe your CD player is failing to work properly, check the following troubleshooting table for tips. Sometimes simple mistakes in setup or operation may appear like serious problems. There are also times when the problem in question may be caused by something else other than your CD player, and at times like these you should check any other electronic devices being used at the same time.
If the problem in question continues to persist even after checking the troubleshooting table below and taking whatever corrective action is recommended, contact your nearest Pioneer Service Station or contact the store from which you purchased your player for further assistance.
Description of problem |
| Possible cause of problem |
| Recommended action |
|
|
|
|
|
A disc fails to be ejected even after the | ÷ | Power cord has not been plugged in. | ÷ | Plug in power cord. |
EJECT button (0) has been pressed. | ÷ | A track is being played back. | ÷ | Set the player to pause or cue standby mode |
|
|
|
| before pressing the EJECT button (0). |
| ÷ | EJECT button (0) is broken. | ÷ | See p. 8. |
|
|
|
|
|
Playback doesn’t begin even when a | ÷ | Auto Cue function is turned ON. | ÷ | Press the PLAY/PAUSE button (38) to begin |
disc is inserted. |
|
|
| play. |
|
|
| ÷ | Hold the TIME MODE/AUTO CUE button |
|
|
|
| depressed for 1 second or more to set the |
|
|
|
| Auto Cue mode to OFF. |
|
|
|
|
|
Playback comes to a halt almost | ÷ | Disc has been inserted upside down. | ÷ | Reinsert with label side facing upward. |
immediately after it begins. | ÷ | Disc is dirty or covered with condensation. | ÷ | Wipe disc to remove dust or condensation. |
No sound is output. | ÷ | Audio cable has come loose or has not been | ÷ | Plug in audio cable properly. |
|
| properly plugged in. |
|
|
| ÷ | DJ mixer is not working properly. | ÷ | Check switch and volume settings on DJ |
|
|
|
| mixer. |
| ÷ | Jacks or jack plugs are dirty. | ÷ | Wipe away dust or dirt and reinsert plugs. |
| ÷ | Player is currently in pause mode. | ÷ | Press the PLAY/PAUSE button (38) to begin |
|
|
|
| play. |
|
|
|
|
|
Sound is distorted or full of noise. | ÷ | Audio cable has not been properly plugged in. | ÷ | Connect audio cable to line input jack of DJ |
|
|
|
| mixer. Do not connect to microphone jack. |
| ÷ | Jacks or jack plugs are dirty. | ÷ | Wipe away dust or dirt and reinsert plugs. |
| ÷ | Player is subject to noise from a nearby television | ÷ | Turn off power to television set or move |
|
| set. |
| television set further away from CD player. |
|
|
|
|
|
A large amount of noise is generated | ÷ | Disc is seriously warped or scratched. | ÷ | Replace with new disc. |
when playing back a certain disc or | ÷ | Disc is unusually dusty or dirty. | ÷ | Wipe away dust or dirt from disc. |
discs. Playback halts unexpectedly. |
|
|
|
|
Track searching fails to halt with Auto | ÷ | Track searching sometimes takes longer than | ÷ | Hold the TIME MODE/AUTO CUE button |
Cue function turned ON. |
| expected when the length of silent portions |
| depressed for 1 second or more to set the |
|
| between tracks is unusually long. |
| Auto Cue mode to OFF. |
| ÷ If the length of a silent portion between two tracks |
|
| |
|
| is longer than 10 seconds in duration, the second |
|
|
|
| track cannot be played back unless Auto Cue |
|
|
|
| function is turned OFF. |
|
|
|
|
|
|
|
The jog dial doesn’t work. | ÷ | The DIGITAL MODE switch is set to ON. | ÷ | Set the DIGITAL MODE switch to OFF. |
|
|
|
|
|
The jog dial performs a different | ÷ | The jog mode is incorrect. | ÷ | Press the JOG MODE button to select the |
function from that desired. |
|
|
| desired function. |
Back cueing fails to work when the | ÷ | No cueing point has been defined. | ÷ | Specify the desired cueing point. (See p. 13.) |
CUE button is pressed during playback. | ÷ | The DIGITAL MODE switch is set to ON. | ÷ | Set the DIGITAL MODE switch to OFF. |
|
|
|
|
|
Unable to produce loop playback by | ÷ | No cueing point (i.e., starting point) has been | ÷ | Specify the desired cueing point. (See p. 13.) |
pressing the LOOP OUT/OUT ADJ |
| defined. |
|
|
button. | ÷ | The DIGITAL MODE switch is set to ON. | ÷ | Set the DIGITAL MODE switch to OFF. |
Unable to perform DJ operations | ÷ | The DIGITAL MODE switch is set to ON. | ÷ | Set the DIGITAL MODE switch to OFF. |
Auto cue and other settings are not | ÷ | The power was turned off right after a setting was | ÷ | Wait 10 seconds before turning off the |
stored. |
| made. |
| power after a change. |
WAVE data is not stored. | ÷ | The data is stored when playback of the current | ÷ | Wait until playback of the current track is |
|
| track is completed. |
| completed. |
|
|
|
|
|
HOT CUE data is not stored. | ÷ | The HOT CUE data is stored in memory when the | ÷ | Eject the disc. (Then turn off the power.) |
|
| disc is ejected. |
|
|
|
|
|
|
|
Television pictures are distorted or | ÷ | Interference caused by CD player. | ÷ | Turn off the power to the CD player or move |
noise appears in FM broadcasts. |
|
|
| the player further away from the radio or |
|
|
|
| television set. |
|
|
|
|
|
Disc is not rotating even though power | ÷ | Disc rotation is automatically halted when no | ÷ | Press the PLAY/PAUSE button (38) to begin |
has been turned on. |
| operation is performed for 80 minutes or longer |
| playback. Alternatively, press the EJECT |
|
| when in pause mode. |
| button (0) to eject the disc. |
| ÷ When the last track on the disc is over the disc |
|
| |
|
| stops rotating. |
|
|
|
|
|
|
|
32<DRB1306>
En