Pioneer CMX-3000 Error Message Display, Cleaning the Jog Dial, Appendix Troubleshooting

Appendix

Troubleshooting

÷There may be times when the CMX-3000 fails to operate properly as a result of static electricity or some other form of interference from an outside source. If any such problem occurs, turn off the power to the CMX-3000, wait for the currently inserted disc to come to a full stop, and then turn on the power again to see if that fixes the problem in question.

÷The CMX-3000 cannot be used to replay partially-written CD-R or CD-RW discs.

÷The CMX-3000 cannot be used to replay non-standard-shaped discs or any discs other than 5 inch/12 cm discs or 3 inch/8 cm discs which have been inserted into an 3 inch/8 cm disc adapter. (Note that attempting to replay such discs may result in damage or breakdown.)

÷The BPM value measured by the CMX-3000 may differ from the BPM value recorded on a CD or from our DJ mixer, but this difference is a result of differences in the BPM value measurement method; not a result of a fault with the player.

Error Message Display

When the CMX-3000 CD player is unable to operate properly, an error code is displayed on the display panel. Check the error code displayed against the following table and take the recommended action to correct the error. If an error code other than any of the error codes listed in the table below is displayed or if the same error code is displayed even after corrective action has been taken, contact your nearest Pioneer Service Station or contact the store from which you purchased your player for assistance.

Error Code	Error Type	Description	Possible cause and recommended action
E-7201	TOC READ ERROR	Player unable to read TOC data.	Disc is cracked.
			= Recommended action: replace disc.
E-83 01	PLAYER ERROR	Player unable to play back currently	Disc is soiled or dirty.
E-83 02		inserted disc.	= Recommended action: clean disc.
E-83 03
			If other discs play normally, the problem is with the
			disc itself.
E-91 01	MECHANICAL TIME OUT	Mechanical operation has failed to	Dust or some other form of foreign particles have
		complete within specified time interval.	found their way into disc insertion slot.
			= Recommended action: remove dust or other
			foreign particles.

English

Cleaning the Jog Dial

To clean the PLAYER wipe with a polishing or a soft, dry cloth. For stubborn dirt, moisten a soft cloth with a weak solution of neutral detergent (diluted in five to six parts water), wring the cloth well, and wipe away the dirt. Use a dry cloth to wipe the surface dry. Applying alcohol, paint thinner, benzene, insecticides, or other stringent substances to the jog dial may cause the markings or finishing of the dial to peel or become discolored, and the use of any such substances should accordingly be avoided.

Published by Pioneer Corporation.

Copyright © 2001 Pioneer Corporation.

All rights reserved.

<DRB1306> 33 En