8.8.2I/O Module
Warning Do not remove this module unless a replacement can be immediately added. The system must not be run without all units in place.
To remove the I/O Module:
1Release the two latches on the bottom of the unit by simply pulling each latch out and away from unit.
2Pull the latches forward to cam the module out of the enclosure.
3Grip the unit securely and withdraw the module.
To installing the I/O Module:
4With the latches in the open position, slide the EBOD module into the enclosure until the latch engages automatically.
5Cam the module home by manually closing the latches. A click should be heard as the latch engages.
8.8.3Replacing the Drive Carrier Module
Warning Observe all conventional ESD precautions when handling drive enclosure modules and components. Avoid contact with backplane components and module connectors, etc.
Instructions are also clearly labeled on the inside cover of the enclosures.
Figure 8–2 Drive Carrier - Handle Released
Caution Drive spin down
Damage can occur to a drive if it is removed while still spinning. If possible, use the operating system to
126 |
|
