APC 15000 RAID manual When a Telnet Session is Active, 54Telnet Statistics

Controller Management

Figure 3–54Telnet Statistics

The administrator is strongly advised to perform any commands affecting the system’s configuration from the CLI UART only (and not from a Telnet session), and to only perform such commands after issuing the TELNET DISABLE command, so that remote users cannot log into the system in the middle of an administrative command.

3.6.1When a Telnet Session is Active

Whenever a remote Telnet session is active, the current RS-232 console switches to a CLI sub-shell which allows the administrator to enter a very limited sub-set of the CLI commands. The following message is displayed on the console when a Telnet session is initiated from a remote site (Figure 3–55).

15000 [1]:

New TELNET Session initiated from IP address: 010:123:139:005

[Remote TELNET session ON] Local SUBshell 15000 [1]:

Figure 3–55Telnet Session Initiated

007-5510-002 77