Controller Management

3.8Other Utilities

3.8.1APC UPS SNMP Trap Monitor

APC_UPS displays the status of the APC UPS SNMP trap monitor (Figure 3–61).

15000 [1]: apc_ups

APC UPS SNMP trap monitor is off.

No APC UPS faults detected via SNMP trap.

Figure 3–61APC UPS SNMP Trap Monitor Status

APC_UPS CLEAR_FAULTS will delete all pending APC UPS faults from the fault list. All APC UPS events that disabled writeback caching will be cleared.

3.8.2API Server Connections

The API command displays the current status of the API connections (Figure 3–62).

15000 [1]: api

API Server connections are currently -- ENABLED--

Figure 3–62Displaying Status of API Connections

API DISABLE temporarily enables/disables the establishment of connections to the API server. When disabled, users at remote locations will be unable to establish a new API connection until an

API ENABLE command is issued. This command only provides control over API connections during the current power cycle.

API STATS displays the collected statistics on API connections (Figure 3–63).API CLEARSTATS resets the collected statistics.

Figure 3–63API Server Connection Statistics

3.8.3Changing Baud Rate for the CLI Interface

The CONSOLE command displays the current serial console setting (Figure 3–64)of the controller.

007-5510-002

81

Page 95
Image 95
APC 15000 RAID manual Other Utilities, APC UPS Snmp Trap Monitor, API Server Connections