APC 15000 RAID manual Host ID, Host Status

Controller Management

The PORT=XALL parameter specifies the specific host port(s) (1 to 4) to be affected when used in combination with any of the other parameters: ID, TIMEOUT, SPEED (for FC only), or WWN. The default is to apply changes to ALL host ports.

Figure 3–5FC Host Ports Configuration Screen

Figure 3–6IB Host Ports Configuration Screen

3.2.1.1Host ID

HOST ID=<new ID> changes the hard loop ID of a host port. The system selects a soft ID if the hard loop ID is already taken by another device. This parameter is entered as an 8-bit hex value. The default value is EF.

Host WWN

HOST WWN=XDEFAULT overrides the system ID and specifies a different World Wide Name (WWN) for a host port. This parameter is entered as an 64-bit hex value. Default WWN is based on the serial number of the unit.

3.2.1.2Host Status

HOST STATUS displays the loop status of each host port (Figure 3–7).

007-5510-002 33