Avaya P332MF manual Set interface ppp

Chapter 6 CLI – Layer 2

set interface ppp

Use the set interface ppp command to configure the P330 PPP interface IP parameters, exit modem mode, disconnect the PPP session, or reset the connected modem.

A PPP connection can be established only after the P330 is configured with an IP address and net-mask. The IP address is a dummy address that is shared between two peers, and must be taken from a subnet that is different from the agent’s IP sub- net.

The syntax for this command is:

set interface ppp <ip_addr><net-mask>

ip_addr	IP address used by the P330 to connect via its PPP interface
net-mask	Subnet mask used by the P330 to connect via its PPP interface

Output Example:

P330-N> set interface ppp 149.49.34.125 255.255.255.0

Interface ppp has its ip address set

You can also use the set interface ppp command to enter modem mode, enter terminal mode, disconnect the PPP session or to reset the connected modem.

The syntax for this command is:

set interface ppp {enableenable-alwaysdisableoffreset}

enable	Enable PPP and enter modem mode.
enable-always	Enable automatic reentry into modem mode after modem cable
	disconnection or reconnection.
disable	Disable PPP and enter terminal mode
off	Disconnect the active PPP session.
reset	Reset the connected modem.

Output Example:

P330-N> set interface ppp reset

PPP has reset the connected modem.

98 Avaya P332MF User’s Guide