Avaya P332MF manual Show port blocking

Chapter 6 CLI – Layer 2

show port blocking

Use the show port blocking command to display the port blocking mode on a particular switch. Use the session command to change switches before using this command.

The show port blocking command is used with the

show self-loop discovery command to confirm a port’s blocking mode.

The syntax for this command is:

show port blocking

Note: This command is not supported by the P330-ML switches.

Note: If this command is to be implemented on a switch other than the stack master, a session should be opened to the relevant switch.

Avaya P332MF User’s Guide 55