Avaya P332MF manual Set inband vlan value, Set vlan, Set port flowcontrol

Chapter 6 CLI – Layer 2

The syntax for this command is:

set inband vlan <value>

value A VLAN number between 1 and 3071.

Output Example:

P330-N# set inband vlan 1

Management VLAN number set to 1

set vlan

Use the set vlan command to create VLANs.

The syntax for this command is:

set vlan <vlan-id> [name <vlan-name>]

vlan-id	vlan number
vlan-name	vlan name

Output Example:

P330-N# set vlan 3 name v3

VLAN ID 3 is named v3.

Note: If you wish to define a name which includes spaces, you must enclose the entire name in quotation marks, e.g. "new york".

set port flowcontrol

Use the set port flowcontrol command to set the send/receive mode for flow-control frames (IEEE 802.3x or proprietary) for a full duplex port. Each direction (send or receive) can be configured separately only for Gigabit Ethernet ports. Proprietary flow control cannot be configured on Gigabit ports. The set flowcontrol command cannot be used on Gigabit ports for which autonegotiation is enabled.

The syntax for this command is:

set flowcontrol [direction] [module/port] [value]

where the parameters of direction are receivesendall, and the parameters of value are onoffproprietary.

112 Avaya P332MF User’s Guide