Avaya P332MF manual Removing an Existing Expansion Module

Appendix A Specifications

Removing an Existing Expansion Module

1Loosen the screws by turning the knobs.

2Grasp the two knobs one near each side of the front panel, and pull gently but firmly towards yourself.

3Insert another expansion module or the blanking plate.

Note: The Avaya P330 switch must not be operated with the expansion slot open; the expansion module should be covered with the supplied blanking plate if necessary.

Note: X330GT2 Modules are hot swapable and can be inserted or removed in an operating base unit.

Cabling

A Category 5 copper cable with RJ-45 termination should be used. You should use all eight wires in the cable.

The maximum copper cable length connected to a 1000Base-T port is 100 m (328 ft.)

154 Avaya P332MF User’s Guide