Avaya P332MF manual Session, Terminal

Chapter 6 CLI – Layer 2

session

Use the session command to open a session with a specific entity in a switch of the stack. For example, you can open a session with the Routing entity of a P332G-ML switch in the stack, or with an the X330 ATM sub-module entity plugged into a specific switch.

The syntax for this command is:

session [<mod_num> [switchrouteratmmgpwan]]

mod_num	(optional) The switch number.
	If you do not specify this parameter, you will
	get the default entity of the stack (Layer 2
	session to the Master)
switchrouteratmmgpwan	(optional) The entity to which you want to
	open a session.
	If you do not specify this parameter, you will
	get the default entity of the specific module:
	switch - Layer 2 entity of the switch (see
	Note below).
	router - Routing entity.
	atm - ATM entity.
	mgp - Media Gateway Precessor.
	wan - WAN access router entity.

Note: Layer 2 commands are only available if you open a switch session with the Master switch.

Note: When you use the session command the security level stays the same.

terminal

Use the terminal width and terminal length commands to set the width and length of the terminal display in characters.

The syntax for this command is:

terminal {widthlength} [<characters>]

40 Avaya P332MF User’s Guide