Avaya P332MF manual Set internal buffering modnum maxmedmin, Set boot bank value

Chapter 6 CLI – Layer 2

set internal buffering

The set internal buffering command allows you to set the size (either Maximum or Minimum) of the Receive (Rx) buffer allocated to each port of the specified switch. This command is meaningless when any port of the switch is operating with flow control ON.

Note: This command is not supported by P332G-ML and P332GT-ML switches.

The syntax for this command is:

set internal buffering <mod_num> {maxmedmin}

max	Sets the internal receive buffer to its maximum size.
med	Sets the internal receive buffer capacity dynamically
min	Sets the internal receive buffer to its minimum size (this is the
	Default).

Example:

P330-N> set internal buffering 1 max

Done.

set boot bank

Use the set boot bank command to configure the software bank from which the switch will boot at the next boot process. This command should be issued separately for each switch in the stack using the session command.

Note: This command is not supported by the P333R and P333R-LB switches.

Note: If this command is to be implemented on a switch other than the stack master, a session should be opened to the relevant switch.

The syntax for this command is:

set boot bank <value>

value {bank-a bank-b}

Avaya P332MF User’s Guide 107