Avaya P332MF manual CLI Layer, User Level Commands

Chapter 6

CLI – Layer 2

This chapter provides all the Layer 2 CLI commands, parameters and their default values.

The CLI is command-line driven and does not have any menus. To activate a configuration option, you must type the desired command at the prompt and press Enter.

Note: The terms “module” and “switch” are used interchangeably.

User Level Commands

This section describes all commands that are available from the User level.

Following is a table of the User Level commands and command groups (all commands are also available at the higher levels).

• session	Opens a session to another P330 switch, X330	Page 40
	ATM Access sub-module, X330 WAN Access
	sub-module or G700 MGP.
• terminal width	Displays or sets the width of the terminal	Page 40
	display.
• terminal length	Display or set the length of the terminal	Page 40
	display.
• clear screen	Clears the current terminal display.	Page 41
• show1	Shows the current switch parameters.	Page 42
• ping	Sends ICMP echo request packets to another	Page 41
	node on the network.
• dir	Show files in the system.	Page 79

1This command corresponds to a group of commands and is shown in a separate Table on Page 42.

Avaya P332MF User’s Guide 39