Chapter 6 | CLI – Layer 2 |
|
|
set port speed
Use the set port speed command to configure the speed of a
Note: This command does not apply to
The syntax for this command is:
set port speed <mod_num>/<port_num> {value}
Output Example:
To configure port 2 on module 2 port speed to 10 Mbps:
Port 2/2 speed set to 10 Mbps.
set port duplex
Use the set port duplex command to configure the duplex mode of a
Note:
The syntax for this command is:
set port duplex <mod_num>/<port_num> {fullhalf}
Example:
To set port 1 on module 2 to full duplex:
Port 2/1 set to
Avaya P332MF User’s Guide | 101 |