Cisco Systems 3750E manual Provisioning a New Member for a Switch Stack

Chapter 5 Managing Switch Stacks

Configuring the Switch Stack

Beginning in privileged EXEC mode, follow these steps to assign a priority value to a stack member: This procedure is optional.

	Command	Purpose
Step 1
	configure terminal	Enter global configuration mode.
Step 2
	switch stack-member-number priority	Specify the stack member number and the new priority for the stack
	new-priority-number	member. The stack member number range is 1 to 9. The priority value
		range is 1 to 15.
		You can display the current priority value by using the show switch user
		EXEC command.
		The new priority value takes effect immediately but does not affect the
		current stack master. The new priority value helps determine which stack
		member is elected as the new stack master when the current stack master
		or switch stack resets.
Step 3
	end	Return to privileged EXEC mode.
Step 4
	reload slot stack-member-number	Reset the stack member, and apply this configuration change.
Step 5
	show switch stack-member-number	Verify the stack member priority value.
Step 6
	copy running-config startup-config	(Optional) Save your entries in the configuration file.

Provisioning a New Member for a Switch Stack

Note This task is available only from the stack master.

Beginning in privileged EXEC mode, follow these steps to provision a new member for a switch stack. This procedure is optional.

	Command	Purpose
Step 1
	show switch	Display summary information about the switch stack.
Step 2
	configure terminal	Enter global configuration mode.
Step 3
	switch stack-member-number provision	Specify the stack member number for the preconfigured switch. By
	type	default, no switches are provisioned.
		For stack-member-number, the range is 1 to 9. Specify a stack member
		number that is not already used in the switch stack. See Step 1.
		For type, enter the model number of a supported switch that is listed in
		the command-line help strings.
Step 4
	end	Return to privileged EXEC mode.
Step 5
	show running-config	Verify the correct numbering of interfaces in the running configuration
		file.
Step 6
	show switch stack-member-number	Verify the status of the provisioned switch. For stack-member-number,
		enter the same number as in Step 1.
Step 7
	copy running-config startup-config	(Optional) Save your entries in the configuration file.

Catalyst 3750-E and 3560-E Switch Software Configuration Guide

OL-9775-02 5-23