Cisco Systems 3750E manual Applying Cisco-Default Smartports Macros, Show parser macro, 12-6

Chapter 12 Configuring Smartports Macros

Configuring Smartports Macros

This example shows how to apply the user-created macro called snmp, to set the hostname address to test-server, and to set the IP precedence value to 7:

Switch(config)# macro global apply snmp ADDRESS test-server VALUE 7

This example shows how to debug the user-created macro called snmp by using the macro global trace global configuration command to find any syntax or configuration errors in the macro when it is applied to the switch.

Switch(config)# macro global trace snmp VALUE 7

Applying command...‘snmp-server enable traps port-security’ Applying command...‘snmp-server enable traps linkup’ Applying command...‘snmp-server enable traps linkdown’ Applying command...‘snmp-server host’

%Error Unknown error.

Applying command...‘snmp-server ip precedence 7’

This example shows how to apply the user-created macro called desktop-configand to verify the configuration.

Switch(config)# interface gigabitethernet1/0/2

Switch(config-if)#macro apply desktop-config

Switch(config-if)# end

Switch# show parser macro description

Interface Macro Description

--------------------------------------------------------------

Gi1/0/2 desktop-config

--------------------------------------------------------------

This example shows how to apply the user-created macro called desktop-configand to replace all occurrences of VLAN 1 with VLAN 25:

Switch(config-if)#macro apply desktop-config vlan 25

Applying Cisco-Default Smartports Macros

Beginning in privileged EXEC mode, follow these steps to apply a Smartports macro:

	Command		Purpose
Step 1	show parser macro		Display the Cisco-default Smartports macros embedded in the switch
			software.
Step 2	show parser macro macro-name		Display the specific macro that you want to apply.
Step 3	configure terminal		Enter global configuration mode.
Step 4	macro global {apply trace}		Append the Cisco-default macro with the required values by using the
	macro-name [parameter {value}]		parameter value keywords and apply the macro to the switch.
	[parameter {value}] [parameter		Keywords that begin with $ mean that a unique parameter value is
	{value}]		required.
			You can use the macro global apply macro-name? command to display
			a list of any required values in the macro. If you apply a macro without
			entering the keyword values, the commands are invalid and are not
			applied.
Step 5	interface interface-id		(Optional) Enter interface configuration mode, and specify the interface
			on which to apply the macro.
Step 6	default interface interface-id		(Optional) Clear all configuration from the specified interface.
		Catalyst 3750-E and 3560-E Switch Software Configuration Guide
12-6			OL-9775-02