Cisco Systems 3750E manual Displaying IPv6 ACLs, Show access-lists, 35-9

Chapter 35 Configuring IPv6 ACLs

Displaying IPv6 ACLs

Use the no ipv6 traffic-filteraccess-list-nameinterface configuration command to remove an access list from an interface.

This example shows how to apply the access list Cisco to outbound traffic on a Layer 3 interface:

Switch(config)# interface gigabitethernet 1/0/3

Switch(config-if)# no switchport

Switch(config-if)#ipv6 address 2001::/64 eui-64

Switch(config-if)#ipv6 traffic-filter CISCO out

Displaying IPv6 ACLs

You can display information about all configured access lists, all IPv6 access lists, or a specific access list by using one or more of the privileged EXEC commands in Table 35-1.

Table 35-1 Commands for Displaying IPv6 Access List Information

Command	Purpose
show access-lists	Display all access lists configured on the switch.
show ipv6 access-list [access-list-name]	Display all configured IPv6 access list or the access list specified by
	name.

This is an example of the output from the show access-listsprivileged EXEC command. The output shows all access lists that are configured on the switch or switch stack.

Switch #show access-listsExtended IP access list hello

10 permit ip any any IPv6 access list ipv6

permit ipv6 any any sequence 10

This is an example of the output from the show ipv6 access-listsprivileged EXEC command. The output shows only IPv6 access lists configured on the switch or switch stack.

Switch# show ipv6 access-list

IPv6 access list inbound

permit tcp any any eq bgp (8 matches) sequence 10 permit tcp any any eq telnet (15 matches) sequence 20 permit udp any any sequence 30

IPv6 access list outbound

deny udp any any sequence 10

deny tcp any any eq telnet sequence 20

Catalyst 3750-E and 3560-E Switch Software Configuration Guide

OL-9775-02 35-9