Chapter 38 Configuring IP Unicast Routing

Configuring OSPF

These sections contain this configuration information:

Default OSPF Configuration, page 38-26

Configuring Basic OSPF Parameters, page 38-29

Configuring OSPF Interfaces, page 38-29

Configuring OSPF Area Parameters, page 38-31

Configuring Other OSPF Parameters, page 38-32

Changing LSA Group Pacing, page 38-34

Configuring a Loopback Interface, page 38-34

Monitoring OSPF, page 38-35

Note To enable OSPF, the switch or stack master must be running the IP services feature set.

Default OSPF Configuration

Table 38-5shows the default OSPF configuration.

Table 38-5 Default OSPF Configuration

Feature

Default Setting

 

 

Interface parameters

Cost: No default cost predefined.

 

Retransmit interval: 5 seconds.

 

Transmit delay: 1 second.

 

Priority: 1.

 

Hello interval: 10 seconds.

 

Dead interval: 4 times the hello interval.

 

No authentication.

 

No password specified.

 

MD5 authentication disabled.

 

 

Area

Authentication type: 0 (no authentication).

 

Default cost: 1.

 

Range: Disabled.

 

Stub: No stub area defined.

 

NSSA: No NSSA area defined.

 

 

Auto cost

100 Mb/s.

 

 

Default-information originate

Disabled. When enabled, the default metric setting is 10, and the

 

external route type default is Type 2.

 

 

Default metric

Built-in, automatic metric translation, as appropriate for each

 

routing protocol.

 

 

 

Catalyst 3750-E and 3560-E Switch Software Configuration Guide

38-26

OL-9775-02

Page 886
Image 886
Cisco Systems 3750E manual Default Ospf Configuration, 38-26