Cisco Systems 3750E Configuring Ieee 802.1x Authentication with WoL, Reinitialize vlan vlan-id

Chapter 10 Configuring IEEE 802.1x Port-Based Authentication

Configuring IEEE 802.1x Authentication

	Command	Purpose
Step 6
	interface interface-id	Specify the port to be configured, and enter interface configuration mode.
		For the supported port types, see the “IEEE 802.1x Authentication
		Configuration Guidelines” section on page 10-23.
Step 7
	dot1x critical [recovery action	Enable the inaccessible authentication bypass feature, and use these
	reinitialize vlan vlan-id]	keywords to configure the feature:
		• recovery action reinitialize—Enable the recovery feature, and
		specify that the recovery action is to authenticate the port when an
		authentication server is available.
		• vlan vlan-id—Specify the access VLAN to which the switch can
		assign a critical port. The range is from 1 to 4094.
Step 8
	end	Return to privileged EXEC mode.
Step 9
	show dot1x [interface interface-id]	(Optional) Verify your entries.
Step 10
	copy running-config startup-config	(Optional) Save your entries in the configuration file.

To return to the RADIUS server default settings, use the no radius-serverdead-criteria, the no radius-server deadtime, and the no radius-server host global configuration commands. To return to the default settings of inaccessible authentication bypass, use the no dot1x critical {eapol recovery delay} global configuration command. To disable inaccessible authentication bypass, use the no dot1x critical interface configuration command.

This example shows how to configure the inaccessible authentication bypass feature:

Switch(config)# radius-server dead-criteria time 30 tries 20

Switch(config)# radius-server deadtime 60

Switch(config)# radius-server host 1.1.1.2 acct-port 1550 auth-port 1560 key abc1234 test username user1 idle-time 30

Switch(config)# dot1x critical eapol

Switch(config)# dot1x critical recovery delay 2000

Switch(config)# interface gigabitethernet 1/0/1

Switch(config)# radius-server deadtime 60

Switch(config-if)# dot1x critical

Switch(config-if)#dot1x critical recovery action reinitialize

Switch(config-if)#dot1x critical vlan 20

Switch(config-if)# end

Configuring IEEE 802.1x Authentication with WoL

Beginning in privileged EXEC mode, follow these steps to enable IEEE 802.1x authentication with WoL. This procedure is optional.

	Command	Purpose
Step 1
	configure terminal	Enter global configuration mode.
Step 2
	interface interface-id	Specify the port to be configured, and enter interface configuration mode.
		For the supported port types, see the “IEEE 802.1x Authentication
		Configuration Guidelines” section on page 10-23.

	Catalyst 3750-E and 3560-E Switch Software Configuration Guide
10-38	OL-9775-02